CV Stepper changing all notes...

[martb]

When after VM restart all cv knobs are set to same value:
- Is the value the same each time when it happens?
- If yes, which value is it?

I just tried this out. I put the CV Stepper into a new empty VM patch and adjusted all the step knobs randomly. I closed and reopened VM and in this case, six out of the eight knobs were set at 1. The other two were at different values.
I've noticed that on initially adding the module all the steps are at 0, however after adjusting the knobs they are mostly set at 1 after restarting VM, but a couple will be at some other value. It seems that it's only the knobs that have been adjusted that will do this, so if you just load the module and close VM without changing any of the knobs then it'll be in the same state on reopening.

I tried again - 'randomized' all the knobs and this time duplicated the module (Alt+drag) so it had identical values, closed and reopened VM and both versions of the module had adjusted to the same values. In this case all but one of the knobs was at 1 and knob three was at 0.75.

cv_stepper_test.jpg (119.31 KiB) Viewed 1344 times

[dayvyg]

Okay, just noticed something. If the voltage is set above 1V then that knob gets set to 1V after closing and re-opening VM. Knobs set below 1V are not affected. This is consistent every time.

Thanks.
d.

[martb]

Okay, just noticed something. If the voltage is set above 1V then that knob gets set to 1V after closing and re-opening VM. Knobs set below 1V are not affected. This is consistent every time.

That appears to be correct. If you set the 'knob range' to 1V then all the knob positions are retained after closing and re-opening.